For Ford 4D Led Car Tail Logo Lights Ford Car Logo Waterproof Rear Badge Lamp
Brand NEW
Product Specifications:

 
Condition: 100% Brand New
Colors available: Blue 
 
The power:DC12V +/-10

Wiring length:0.6meter

Material :LED+PVC+ABS

Voltage:12V

life span:more than 100000 hours

Size: About 14.5*5.6cm/17.6*6.9cm

 
Fit: Ford
 
Note:
Please measure your original Rear and Front logo
before you place an order!

 

Product Features:

 

1:It is easy to install and can be used for more than 10000 hours
2:This product should be installed in the original position
to replace the original logo(at the back of the car)
3:Using high-quality automotive-specific double-sided adhesive,
sticky special strong special lasting!
The use of special vacuum plating technology,
both to ensure the original car with the standard gloss,
but also to ensure high transmittance and brightness uniformity
4:High quality water plating car badge, Laser and Reflective mirror
5:When the license plate lamp is turned on,
the car logo light will be turn on too, which shines the logo in the night .
6:Special waterproof and dustproof design!
This product is designed for car modification enthusiasts,
specially designed during the day and logo does not light,
there is no difference with the original logo.

 
Installation Notes:
 
Before you begin,
 
prepare the following tools:
 
1. Flat head screwdriver
2. Phillips screwdriver
3. Insulating tape 4. Towel 5. Pliers
 
1. First in the box marked with a towel next to the car,
with a flat screwdriver pry the car standard,
shop towel is to prevent scratches the body
2. Note first double-sided tape stripping the body,
when prying force moderate, do not be too fierce, little by little,
slowly pry down,
clean up the car body and the standard double-sided adhesive
3. Using a Phillips screwdriver to remove the inner compartment
of the rear compartment, pay attention to some parts of the clamp,
be careful to remove the noise board can see a variety of lines.
4. Now again to install the car standard lights,
the car lights to mark the power cord through one of the car
standard positioning holes, wear inside the car
Tear off the car on the back of the single-sided plastic lights,
while pulling the side of the car lights to stick to the car body,
pressed.
5. Mark lights installed, and now the power supply.
The car to be connected to the license plate lights after the
license light power,
so when you turn on the night light when the lights will be marked
at the same time to find the license plateafter the power connector
6. First unplug the plug, positive and negative stripping a hole,
revealing wire core, according to the red on the red,
black and black good line,
do not forget to use insulating tape wrapped,
and finally plug the plug back again!
Replace the rear cover noise board!