Description
Length:about
56cm(22")
Width:about
65cm(25.6")
With
printed Instruction
You will
receive a set of colour-printed A4 cards not a finished model
Guide
to build :Basic steps to make Paper Models.
1) Cut out
each part roughly.
2) Use a
pencil to mark note softly behind each part to avoid disorder (Don't use a pen
as it probably makes damaged trace on the front side).
3) Use
Scissor or Craft Knife to cut parts precisely by following the outer edge. The
level of precision affects the effect of combination. (Cut the most outer edge
if the line is thick).
4) Smear
white adhesive cement on one of the 2 parts which needed to be stuck together.
5) Stick
them together until the cement bone-dry.
Suggested
TIPS :
A. For
Scissor cutting, suggest not to push the Scissor but pull the paper.
B. To make
the fold of parts better, please put the part firmly on the table, and put the
ruler on that to fold the line. If you have to fold inside, you could first
fold it softly outside to make the trace, and fold it back to inside then.
C. To make
the curved parts better, place the part on the corner of table then push and
pull it back and forth.
D. To make
parts like cylinder, use tools such as pen to assist to make the curl more
natural.