110V 175W Silicone Heater Pad Engine Oil Pan Tank Car Start Warmer Self-adhesive

The silicon rubber heater is mainly composed of nickel chromium alloy electric heating wire and high temperature silicon rubber insulation layer. Silicone rubber high temperature insulation layer is made of silicone rubber and glass fiber cloth composite and into a thin sheet (1.5mm), silicone rubber heater has a good flexibility.

Features:
＞Fast heating, uniform temperature, high thermal efficiency, high strength, easy to use, safe life for up to four years, not easy to aging.
＞The silicon rubber heater can be used in the wet, non explosive gas environment, industrial equipment, pipelines, tank barrels with heat insulation (oil heater).

＞Can be directly tied to the surface of heated objects.

＞Wire and Pad heater all made by    High-temperature resisting silicone. Ensure long-term use. Oil and acid  resistant, Waterproof.
＞Built-in highest quality thermal overload protection switch for Power saving. Additional safety. Fast heat rises.
＞Keeps engine oil warm. Prevent cold start damage, reduce engine wear.
＞3M high temp adhesive on    reverse side, easy to install.
＞This heater is significantly more efficient and better than a conventional tank heater.
＞Can be used as the auxiliary heating of the refrigeration and air conditioning compressor, motor and other equipment.

＞Can be used as medical devices (such as blood analyzer, test tube heater, medical care, slimming belt corset heat compensation etc.).

Specification:
Material: Alloy wire,Silicone rubber
Color: Orange
Product size:
Heater size: length:13cm width:9cm
Wire length: 200cm
Insulation material the highest resistance temperature: 300 degrees
Power error: 8%
Insulation resistance:≥5 MΩ
Compressive strength: 1500v/5s
Resistance voltage: 6KV
Power:110v 175w

INSTALLATION INSTRUCTIONS FOR SILICONE HOT PAD HEATER:

1. CLEAN AND SAND RESERVOIR TO BARE METAL. REMOVE ALL DIRT, GREASE, OIL AND

OTHER CONTAMINANTS USING A DEGREASING SOLVENT. DO NOT USE GASOLINE OR

ACETONE.

2. IF HEATER IS TO BE INSTALLED ON A VEHICLE, TRY TO RUN THE ENGINE TO    PRE-WARM

THE OIL PAN.

3. PEEL OFF BACKING AND APPLY PAD TO RESERVOIR MAKING SURE THAT THERE ARE NO

AIR POCKETS OR CREASES IN THE PAD. USE A ROLLER OR SPREADER TO REMOVE THEM.

4. SEAL THE EDGES OF THE HEATER WITH HIGH TEMPERATURE SILICONE TO INSURE

PROPER PROTECTION TO THE EDGE OF THE HEATER.

5. SECURE THE CORD UP AND OUT OF THE WAY OF ANY OBSTRUCTIONS, MAKING SURE

THAT IT DOES NOT HANG DOWN FROM THE PAN OR TOUCH ANY HOT OR MOVING

NOTE:
1. Do not cut pad.
2. Do not use on batteries
3. This heater can only be used on a metal pan or tank with a smooth float    surface.. It should never be installed on a plastic or poly container.

Package Included:
1 PC Heater Pad (not with plug)