Water Butt with Barbed Outlets

These water butt adapters are perfect for direct connection to hose pipes from 1/2" (13mm) to 2" (50mm). These barbed fittings can be push fit onto hosepipe, water pipes, corrugated pond pipes & more! Each fitting comes with a single nut and washer to screw into your water tank.

What size hole do I need?

BSP (British Standard Pipe) is a standard pipe thread size used in the UK. The size of a BSP pipe is specified by its nominal diameter, which is measured in inches. However, BSP sizes are different from the actual physical diameter of the thread.

Please note that we always recommend waiting for the product to arrive prior to drilling or permanently altering your water tank.

Installation Instructions:

1. Find the pre-drilled/fitted hole on your tank and see if our adapter is compatible, if it is not compatible then drill a new hole in your place of choice
2. Take the nut off the adapter and leave the washer on the thread, then insert the adapter into the hole from step 1.
3. Then screw on the nut as tight as possible, you do not need to use a tool for this, hand tight with both washers should prevent leaking.
4. Push your pipe onto the connector and tighten with a clip or cable tie to prevent leaking.