20Pcs Fender Liner Push-Type Retainer Clip 7mm For Subaru Impreza Legacy WRX BRZ
Made of high-quality black nylon material, anti-wear, and anti-corrosion, would not break or crack easily during use, push in type, rivet post pressure expands legs for fast and tight fastening
Commonly used for fitting front and rear bumper, fender liner, inner wheel well, side panel /bracket, upper trim, cowl grille, radiators, air deflector, rocker molding, lower shield, rear rocker mldg, front shield, hood, insulator and various trim panels.
Type: Screw-Type with Open End
Drive Type: Phillips
Head Diameter: 20mm
Stem Length: 11mm
Fits Into 7mm Hole
Perfect to replace your old or worn clips.
How to Install
Check the hole size of your car, make sure the hole size is 7mm.
Remove the old clips with a remover tool from your car
Put the two parts of the new clips together
Push the clips into the hole
This means that you will receive 20 push type retainer for ordering quantity 1 of this itemm
Fitment:
For Subaru Replaces 909130051, 90913-0051
For Toyota Replaces 90467-07138, 90467-07138-C0
Notice: Check the hole size of your car, make sure the hole size is 7mm.