Product specification

1.1 Output capacity: continuous current 30A, short-time current 40A (not less than 10 seconds);

1.2 Power input: 5.6V - 16.8V (2-3 lithium battery packs or 5-12 NiMH/NiCd battery packs);

1.3 BEC output: linear regulator mode, 2A

1.4High speed: 2-pole motor 210,000 rpm, 6-pole motor 70,000 rpm, 12-pole motor 35,000 rpm;

1.5 Size: 45mm*24mm*11mm

1.6Weight: 25g

Product function

1.Safe power-up function: When the power is turned on, no matter the throttle rocker is in any position, it will not start the motor immediately to avoid causing personal injury;

2. Throttle stroke adjustment function: adapt to the difference in throttle stroke of different remote controls to improve the throttle stroke.

Throttle stroke adjustment function: adapt to the difference of different remote control throttle strokes, improve the linearity of throttle response, and have smooth and delicate speed control feel and speed control linearity;

3. Program setting items:

Brake setting: without brake/with brake, factory default is no brake.

Battery type: Li-xx (Li-ion battery) / Ni-xx (Ni-Cd or Ni-MH), the default value is Li-xx (Li-ion battery) .

Low Voltage Protection Mode: Reduce Power / Turn Off Output, default value is Reduce Power.

Low voltage protection threshold: low/medium/high, default value is medium cutoff voltage.

When Li-xx batteries are used, the number of Li-ion batteries will be judged automatically, and the cut-off voltage of each battery in low/medium/high case is 2.6V, 2.85V and 3.1V respectively.

When set to use Ni-xx batteries, the ESC automatically detects the voltage of the battery pack when it is powered on, and the cut-off voltage for low/medium/high cases is 0%, 45%, 60% of the input voltage at power-on (0% means no low voltage protection).

Start mode: normal/soft/ultra soft start, default value is normal start.

Normal start is suitable for fixed wing, it can start the motor quickly within 0.2 seconds.

Soft start/Ultra soft start is suitable for helicopter; the initial speed of soft start and ultra soft start are relatively low, it takes 1 second and 2 seconds respectively from start to full speed, but if you close the throttle after start, the motor will be started again in normal mode in 3 seconds, so as to avoid the airplane falling down due to the slow reaction when doing some aerobatic maneuvers.

Approach angle: low/medium/high, default value is medium approach angle.

Generally speaking, low approach angle can adapt to more motors, but in order to improve the efficiency, it is recommended to use low approach angle for 2-pole motors, and use medium approach angle for motors above 6-pole. To increase RPM, the feed angle can be set to a high feed angle. After changing the approach angle setting, it should be tested on the ground before flying.

Restore factory defaults

4. Comprehensive protection functions:

Under-voltage protection: set by user through program;

Over-voltage protection: Input voltage exceeding 18 volts will not start, automatic protection, and at the same time emit a sharp "beep" alarm sound;

Overheating protection: built-in temperature detection circuit, MOS tube temperature is too high when the ESC automatically shut down;

Remote control signal loss protection: reduce power after 1 second of remote control signal loss, and then no remote control signal for 2 seconds will shut down the output;

Process features

1 power supply input using ** ultra-low impedance high-capacity electrolytic capacitors, greatly improving the anti-interference capability;

2 output MOSFET power tubes are equipped with an independent heat sink to reduce device temperature rise and improve the system's ability to work with high current;

3 The use of single-chip computer control;

4 microcontroller using an independent voltage regulator chip, to avoid BEC load changes caused by power supply interference, improve the stability of microcontroller work;

Red positive Black negative Yellow signal line