Audio Technica AT-OC9XEN - Dual Moving Coil Cartridge & Stylus

  • Features low mass nude elliptical stylus and aluminium cantilever
  • A neodymium magnet and pure iron yoke provide increased magnetic energy
  • Aluminium body minimizes unwanted vibration for reduced resonance
  • PCOCC is used for the coils to achieve pure signal transmission
  • Threaded inserts in the cartridge designed to work best with AT-LH15H (EB660) & AT-LH18H (EB661) headshells
Colour Silver
Voltage n/a
Warranty 2 Years
Condition New
Sold as Each
HTFH Cat. No. EB658

Non UK/EU customers, please contact us for accurate shipping rates.

Features

The AT-OC9XEN Dual Moving Coil cartridge with nude elliptical stylus is designed to provide outstanding channel separation. The Pure Copper by Ohno Continuous Casting (PCOCC) coils ensure pure audio transmission and are aligned in a reverse V-shaped formation to exert less pressure on the stylus, thereby minimizing distortion. Audio quality is further enhanced by a rigid aluminum body that reduces resonance, a neodymium magnet and pure iron yoke that increase the magnetic energy, and the low-mass nude elliptical stylus on an aluminum cantilever that accurately tracks the record groove. The cartridge body has been pre-threaded, enabling it to be mounted to a headshell or integral tonearm with just two screws – no nuts required.

Technical Specification

Audio Technica Audio Technica AT-OC9XEN

Model     AT-OC9XEN
Mounting     1/2” centers / Threaded inserts
Frequency Response     20 to 30,000 Hz
Body Material     Aluminium
Channel Separation     25 dB (1 kHz)
Output Channel Balance     1.5 dB (1 kHz)
Output Voltage     0.35 mV (at 1 kHz, 5 cm/sec)
Vertical Tracking Angle     20 degrees
Vertical Tracking Force Range     1.8 to 2.2 g (standard 2.0 g)
Stylus Shape     Elliptical Nude
Stylus Size     0.3 x 0.7 mil
Stylus Construction     Nude square shank
Cantilever     Aluminium pipe
Coil Impedance     12 Ohms (1 kHz)
Coil Inductance     25 μH (1 kHz)
DC Resistance     12 Ohms
Static Compliance     20 x 10 – 6 cm / dyne
Dynamic Compliance     9 x 10 – 6 cm / dyne (100 Hz)
Terminal Pins     Brass
Wire Used for Coil     PCOCC (Copper by Ohno Continuous Casting process.)
Recommended Load Impedance     Min 100 Ohms
Cartridge Weight     7.6 g
Dimensions     17.3 (H) x 16.8 (W) x 25.7 (L) mm
Accessories Included     1 non magnetic screw driver
1 brush
2 washers
4 pairs of mounting screws: 5mm, 8mm, 10mm, 12mm
1 plastic protector

We are Authorized Dealers for all the brands we carry. Why not visit our store for a demonstration?
Visit Our Birmingham StoreNo. 1 Spencer Street, The Jewellery Quarter, Birmingham, B18 6DD, United Kingdom