40mm Aquarium Cichlids Tumbler Tropical Fish Egg Incubator Ornamental Hatchery Fish Eggs Instead Mouth Brooding Accessories
Feature:
1. The curvature of the air lift joint is greater than 90 degrees, which is not common in the market, 45 degrees, the water is more comfortable, and a small air pump can drive it.
2.Connecting parts such as gas lift joints are used in AD.
3. Ultra-transparent thickened acrylic incubator tube with flat incision.
4. The sieve plate hole is 1mm, and the lower sieve plate is glued to the main hatching room to effectively prevent fish eggs from escaping.
5. Filter cotton uses black biochemical cotton, non-black sponge.
5. The bracket is all acrylic for easy observation.
6. Four transparent suction cups, more reliable. It can be used normally even if you change 1-2.

Deduction method:
1. Take out a basin of water from the tank (the water in the tank must be)
2. Carefully remove the female fish.
3. Hold the fish with the fish head facing forward (the butt cannot be pulled out).
4. Use your fingernails to buckle the teeth of the fish's lower jaw. Be careful not to buckle your lips.
5. Push forward and downward. Note that both downward and forward alone are harmful to the fish. Add that it is done in water.
6. Keep the mouth open, keep steady and move against the direction of the fish head in the water.
7. Repeat the exercise until all the eggs are out.
8. If the female fish is removed from her hands, catch it back in time, otherwise she will immediately swallow the eggs in the basin back into her mouth.
9. Take out the female fish. Look at the mouth of the fish with your eyes to make sure it is clean and put it back in the tank.
10. Put the roe into the incubator (if it is fry, put it into the isolation box).
If it is already a seedling, put it in the isolation box and place the isolation box in the tank where there is sufficient water and oxygen.
11. Pay special attention to the whole process. Be sure to use the original tank of water around 1 day after the egg is deducted. For safety, do not change the water.

Specification:
Material: ABS
Size:
Height: 30cm
Diameter: 40mm
Contain: main incubator room, four suction cups, air lift room, biochemical cotton, trachea, sand head.

Note:
1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
2. Please allow 1-2cm measuring deviation due to manual measurement.