Product Details
Features:
1.No contact, as it is not in contact with the suspension, there is no friction, no mechanical wear, low energy consumption, and low noise
2.It does not require supporting media and can be applied under various special conditions such as vacuum, ultra clean, high temperature, and low temperature
3.The force distribution is uniform, so the magnetic levitation support force is evenly distributed throughout the entire magnetic pole surface, greatly reducing stress and improving service life reliability
4.Long term operation without lubrication and maintenance
5.Suitable for students or DIY electronics enthusiasts to learn pull-up maglev
Parameter:
Product name: pull-up maglev
Power supply voltage: 12V 1A-2A
Power consumption: 2-10W
After production, the product size is approximately 6.5CM long * 6.5CM wide * 10CM high
Composition: composed of analog circuit and Hall sensor
The maximum suspended weight is about 50 grams
How to place suspended solids
1. Connect the power supply first.
2. Hold the magnet and slowly approach the coil from bottom to top. When the distance is about 2 centimeters, you can feel the suction provided by the coil. Once it stabilizes, let go.
If the magnetic force is not enough, you can adjust the blue potentiometer on the board for debugging, increasing the magnetic force clockwise and decreasing it counterclockwise,
Adjust the magnetic force to the optimal position, otherwise it will shake.
Matters needing attention
1.Do not let the magnet adhere to the coil when powered on, as it can easily damage the device.
2.Failure to discharge the float for a long time can cause an increase in the temperature of the transistor and coil. It is recommended to unplug the power supply and try again after 5 unsuccessful discharge attempts.
3.Keep magnets away from other electronic products, such as mobile phones, bank cards, etc.
4.Long term load requires an additional fan, otherwise the increase in coil temperature will affect the normal operation of the sensor.
5.The float uses a magnet to attract a 2032 battery, with an LED welded to it, making it feel like a small sun floating in the air. (Shipped without battery)
Package include:
DIY kit * 1
- EBAY Managed Payment. But we only Accept your Ebay Address, please Make sure it's 100% right.
- Payment must be received in 5 business days of auction closing.
- Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
- Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
1. We only ship to the confirmed address provided by eBay. please make sure your ebay address is 100% matches the address you would like us to ship to. If not, please let us know before we sent you the package, or we will not be responsible for any loss. hope you could understand.
2. Orders will be processed instantly and dispatched within 1-3 business days except hoilday, so we do NOT accept any email/message note after you place orders.
3. All package need to wait 30 days,Please take care it.Less than 30 days,we can't take a refund.
- All package need to wait 30 days(US only need 7-10 days),Please take care it.Less than 30 days,we can't take a refund.
- If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please keep in touch with us and double check the return address before you return it.
- If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you keep in touch with us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.