This system is used. Comes with mounting brackets and units. Does not come with a power source.. it was taken out of a working system.
The EZ-Bridge LT+ HD is a high power 25dBm (316mW) outdoor wireless bridge system operating in the 5GHz unlicensed frequency spectrum providing real world throughput up to 100 Mb/sec. It complies with the 802.11g/n or 802.11a/n standards to insure interoperability. The EZBridge LT+ HD creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge LT+ HD units can be connected in a mesh configuration to allow interconnecting more than two sites.
With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.
Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power inserters. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer.
Data Rates
5GHz 802.11n: up to 300Mbps
5GHz 802.11a: up to 54Mbps
�
Standards
IEEE802.11g/n, 802.11a/n, 802.3, 802.3u
�
Power Requirements
Power Supply: 100-240VAC 50/60Hz
EZ-Bridge � : 12VDC to 24VDC Passive PoE
Average Power Consumption: 4W
�
Regulatory Certifications
FCC Part 15 / UL
�
RF Frequency Band
5100 ~ 5850 MHz
�
Modulation Technology
802.11n: TDMA
802.11g: OFDM
802.11a: OFDM
�
Receive Sensitivity (Typical)
802.11n: -90 dBm
802.11g: -75 dBm
802.11a: -75 dBm
�
Transmit Power
25dBm � 316mW
�
DC Connector Power Out
Input Voltage @ Max 10W
Antenna
5GHz 16dBi MIMO Panel Antenna, 27deg Beamwidth, > 22dB front to back
�
Operation Mode � Bridge or Router
Point to Point Bridge, Access Point, Access Point WDS, Client, Client WDS
�
Interface
10/100Mbps RJ-45 LAN Port x 2
�
IP Configuration
Static or Auto configuration using DHCP Client
�
Security
MAC Address Filtering, WEP/WPA encryption, Hide SSID in beacons, Layer 2 isolation
�
Management Configuration
Web-based configuration (HTTP)
Console configuration (SSH)
SNMP Protocol
�
Firmware Upgrade
Upgrade firmware via web browser
�
Antenna Physical Dimensions (L x W x D)
314mm x 187mm x 65mm
12.4� x 7.3� x 2.5�
�
Complete System Weight: 3 kg � (7 lbs )
�
Operating Temperature
-30�C to +70�C (-22�F to 158�F)
�