Features:
*You will get 1 piece long axis 18mm silent clock movement with 11mm thread height, suitable for clock panel with 30~40cm diameter.
*These clock repair replacement parts are suitable for cross-stitch, three-dimensional embroidery, craft clocks, frameless pull clocks, especially suitable as replacement parts for DIY quartz wall clocks.
*This product is accurate timing, time error within 1 second, service life up to 3 years, low power consumption, very environmentally friendly, ordinary batteries can be used for 6 months.
*This movement uses 1 section of 1.5V-AA batteries (can use carbon batteries, alkaline batteries are not recommended, otherwise the current is too high, affecting the time, delivery without batteries)
*This product is suitable for craft clocks, wooden wall clocks, metal wall clocks, electric box wall clocks, porcelain crystal paintings, repair and replacement, DIY home decorative clocks; it can rejuvenate your old clocks and make your new DIY crafts more perfect.
*No ticking sound, only the second hand sweeping instead of ticking, making the movement quieter.
Details:
Material: plastic, metal
Color: Black hands, black and red hands, black seconds point
Size:
Movement size:
Movement specification: 56*56*16mm, shaft length 18mm, thread height 11mm, suitable for 5~8mm thick clock plate.
Hand size:
Hour hand (measured from the round hole to the top): 85.5mm
Minute hand (measured from the round hole to the top): 129.5mm
Second hand (measured from the round hole to the top): 133mm
Application: for 11~15.7 inch wall clock/30~40 cm diameter clock panel
Battery: 1 x 1.5V-AA battery (battery not included in delivery)
Package contents:
Delivery list: clock movement, hands, accessories.
Caution:
1. Due to various factors, such as monitor brightness, light brightness, etc., the actual color of the product may be slightly different from the picture shown on the website.
2. Please allow slight manual measurement deviation in the data.
3. Please refer to the installation diagram of the pointer for the installation method of the pointer.
4. After the three pins are installed, the three pins should be parallel when viewed from the side, and it is best not to touch the pins.