Holybro Remote ID WIFI / Bluetooth-Compatible Supported in PX4 / Ardupilot CAN Serial Protocol For RC Model Drone Quadcopter
Holybro RemoteID Module is low cost, small size, and light weight module that broadcast information about UAVs in flight through WIFI & Bluetooth-Compatible. It supports both CAN and serial protocols. It is a FCC & CE approved radio module.
Note: This product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, as you need to do your own approval process at the FAA (DoC submission) if you are in the USA. For the most accurate and latest information related to this topic, please refer to the official governance website of your country.
Specification
Radio module:
Espressif ESP-C3 module
Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW)
FCC & CE certified radio module
Firmware:
ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID).
Supports upgrading firmware via the web interface (“OTA”)
Supported in PX4 & Ardupilot
Protocol: CAN & Serial
Interface:
1x JST GH 4-pin CAN (CAN) port
1x JST GH 6-pin TELEM (UART) port
Antenna Connector type:
On CNC Case: SMA connector
On PCB: IPEX Connector
Range: > 5km detection range*
Power: 5V supplied from TELEM or CAN port
LED lights: Bright RGB status LED
Size:
Without case: 35.3 x 23.5 mm (not including antenna)
With CNC case: 38 x 26.5 x 11.5 mm (not including antenna)
Mount: M2 screws
Operating temperature: -40°C to +85°C
Weight:
PCB only: 4 g
With CNC case & Antenna: 27.5g
Without case & Antenna: 16.5g (Cable 20cm)
Certification: FCC& CE