Turn Signal Indicator Lens for

Kawasaki

1994-2004 ZX600E/ZZR600

ZZR250 Front Signals

Smoke lens





Since 2002 we started to design and produce motorcycle Led Lighting System ,Till 2009 our products already covered full range of Brand motorcycle's Tail Lights and Turn Signals, such like: Aprilia,Articat,BMW,Buell,Ducati,Harley Davison,Honda Kawasaki, Mv Agust,SuzukiYamaha, etc.

All of our products are designed in USA, made as required by DOT & E-Mark.


FEATURES:
Specific tail light for the above-mentioned models, Improve the look and lighting of your motorcycle
Fixed in the place of your original light without any changes
Maximum Quantity LED installed if applicable
Included connectors and resistors if applicable
Guarantee 3 months
Installation:

Wiring Diagram:

Black Wire(Negative),

Green Wire(Brake)

Red Wire(Running Light)

Connect the YELLOW wires to the positive turn signal wires using provided red connectors or

alternately use your existing factory connectors. Ground wire is not needed unless you are

using resistors to slow down the blinking rate. The ground wire is the same color wire used on

both turn signals.

To slow down the blinking rate use provided resistors.

1. Connect one end of the resistor to the ground wire on your turn signal harness from your bike.

2. Connect the other end of the resistor to both the YELLOW wire from our taillight and the positive

turn signal wire from your turn signal harness from your bike.

3. Repeat the same process for the other side.

To use the red connectors, place one wire inside along one channel, place another wire inside along

the other channel. Push down the metal pin as it will make a small cut on each wire bridging the connectors.

if you are using the resistors, place one end of the resistor in the middle of either channel along with the one wire.