Deep-drawn from robust ABS plastic. Either made of silver-colored ABS plastic with a high-strength clear plastic protective layer or, for professional users, in a very abrasion-resistant, black hybrid material

(fabric-reinforced). So you can act without worries and at the same

time the frame is safe from you and your boots!

The facts:

1.The boot can no longer be tilted or caught on the protector or frame

2.Protection of the frame from scratches by enduro boots

3.Protects the swing arm bearings against dirt

4.Prevents the loss of the swing arm bearing plugs

5.Perfect fit. Rattling and chafing is impossible

Weight:

only 80 g per side

Installation sequence?

First, clean and degrease the frame in the areathe frame protector.

1. First glue in the area of the frame protectorsthe enclosed foam rubber on the frame tubes.

2. Remove the protective film (only applies to silver/black Item) from the frame protectors, pull the Cable ties through the frame protectors and around the Frame, pull the cable ties evenly (Locks should point to the center of the vehicle) and cut off the protruding ends of the cable ties from.