Features:
Description:
l 1. Remove the screws that fix the resin bucket on the side where you want to install the drip stand
l 2. Fix the drip holder as a whole to the thread, and then tighten the thumb screw again
l 3. During the printing process, the drip tray cannot touch your bottom plate
l 4. After printing, move up the build platform
l 5. Remove the platform and hang it on the bracket
l 6. The uncured resin will drip back into your trough
l 7. You can close the lid as needed
Specification:
l Size: length about 50mm, width about 20mm, height about 55mm
l Applicable models: Phrozen Sonic Mini, Most other 5.5″ / 6″ LCD 3D Printers where the resin vat is secured with thumbscrews
Packing includes:
l 1 x Resin Drip Stand
Note:
l Not applicable models: all models of Anycubic (the printing platform is different)
![](https://img1.tongtool.com/r/trttCytBrvtvuqtvrytwwtxywCzBxBzBtCzsMSJ6.jpg)
![](https://img1.tongtool.com/r/hfhhqmhpfjhjiehjfmhkkhlmkqoipljjmjpgAGxM.jpg)
![](https://img1.tongtool.com/r/7577gc7f597984795c7aa7bcb7abecdf89f6qwnJ.jpg)
![](https://img1.tongtool.com/r/AyAAJFAIyCACBxACyFADDAEFEAEDBDBJAEAzTZQr.jpg)