When installing this throttle assembly for the first time, be sure to ten the throttle assembly for initialization operations. The steps are as follows.

1. After the installation is completed, unplug the negative terminal of the battery cable and reattach it after 1 minute. Turn the key to the second gear (instrument lights on the gear) and wait 30 seconds, and then ignition.

2. Wait about 30 seconds after ignition; step on the gas pedal to the engine for 3,000 4,000 rpm, hold for 10 seconds; release the accelerator to the specified idle state hold for 10 seconds.

3. Turn off the ignition switch and pull out the key, the initialization is complete.

4.If the first time is not successful, repeat the above procedures until successful (generally do once can be successful, up to two times).