SHIP ALL ITEMS WITHIN 24 HOURS

USPS FIRST CLASS WITH TRACKING NUMBER SERVICE

Welcome Retail, Wholesale & Drop-Shipping!

Scope of application: suitable for IDE optical drives, burners, 3.5-inch hard disk drives, VCR hard disk drives

Compatible system: Compatible with windowsXp\win7\win8 32-bit/64-bit systems.

Compatible support for all brands of desktop computers:

1, VCR IDE hard disk to SATA, connected to the motherboard SATA port.

2, 3.5-inch IDE hard disk to SATA, connected to the motherboard SATA port use.

3, IDE CD-ROM drive to SATA, connected to the motherboard SATA port.

4, IDE burner to SATA, connected to the motherboard SATA port use.

5, desktop 3.5-inch IDE hard drive can be adapted to use in SATA video recorders (please format the hard disk on the computer first).

6, after the transfer of the hard disk can be used as a master disk, slave disk (need to reinstall the system, refresh in the BIOSS, etc.).

7, the optical drive after the adapter can be guided to do the system.

8, the adapter card supports a maximum capacity of 1000G parallel port hard disk.

9, the use of adapter IDE devices, jumper caps must be inserted in the position of the MASTER.

10, compatible with SATA 1 generation, SATA 2 generation, SATA 3 generation.

11, plug and play, do not need any driver!

The product can not be used for common failures:

1, check to see if the SATA cable problem, see if there is no loose. Or change a normal use of the SATA cable.

2, test whether the jumper to the main disk, the value of the MASTSER position.

3, boot BIOS settings in the correct. Part of the motherboard needs BIOS settings (SATA mode set to IDE MODE).

4, if it still can not be used may be a compatibility problem, such conversion card has a small number of devices have compatibility problems.

5, compatibility due to the product does not recognize the reasons behind the good, the following share. When it can not be recognized: Right click on "My Computer - Properties" - "Hardware" - "Device Manager". Then open the "IDE ATA/PATA controller" and then double-click the primary and secondary IDE channel, select "Advanced Settings", set the "Device Type" to "Auto Detect", and "Transmission Mode". Set "Transfer Mode" to "DMA (if available)" - click Confirm. Reboot to see if the system found new hardware.

6, this model does not support the motherboard IDE interface to SATA hard disk, etc., please note that the purchase.

Installation steps:

Plug and play, do not need to install any driver support IDE motherboard with SATA hard disk.

1. Turn off the computer, open the chassis.

2. Set the jumper into the main disk position.

3. Plug the IDE power cable into the IDE port of the chassis.

4. Insert the SATA power cable into the chassis SATA interface. 

5. Insert the SATA cable into the chassis interface.

6. Reboot the computer, the installation is complete.