Automotive Dual Battery System Isolator Kit with 140A Voltage Sensitive Relay
DESCRIPTION


features:

1. The installation is simple and suitable for the medium voltage sensing split charging relay that can safely charge 75A to 120A leisure batteries.

2. The voltage sensing relay only detects the voltage rise in the vehicle charging , so that you can charge the leisure battery when the engine is running.

3. When the engine is turned off, the relay will separate your leisure battery from the main starter battery. Therefore, it will not drain the battery of the main starter, and you will always be able to start the vehicle.

4. This tool kit is applicable to campers, motorhomes, 4x4s, Day Van, mobile workshops, cars or ships.

5. Add soldering points to enhance heat dissipation


When the engine is started, the starting battery and auxiliary battery are separated, and only the starting battery is allowed to be charged. When the charging voltage reaches 13.3 V, the VSR is engaged to charge the starting battery and auxiliary battery. This is indicated by the red indicator light on the top of the LH. When the engine stops running and the battery voltage drops below 12.8 volts, the VSR disengages, separating the starting battery from the auxiliary battery. The auxiliary battery will continue to power all accessories without consuming the power of the starting battery.

The VSR is "dual induction", which can sense the voltage of two batteries. This is very useful because it is dual induction (two-way). You have connected the battery charger or solar energy to the auxiliary battery and the battery is fully charged. The VSR will then allow your charging source to recharge the crank battery and fully charge it, but again, if the voltage drops below 12.8 V, the VSR will disconnect (isolate) the battery again.


Specifications:

Type: voltage  sensitive relay

Continuous current: 140A

Maximum current: 160A

Consumption current - charging: 280mA

Current consumption - standby: 8mA

Disengagement delay: 5-10 seconds

Recommended fuse: 80Amp

Power stud: M6 stainless steel

Surge protection: built-in

Package product weight 500 g

Package size 18 * 18 * 7cm


Package includes:

1 * 12V 140A voltage detection split charging relay

1 * Cable 30cm black

1 * Cable 30cm red line

1 * Cable 60CM red line

3 * 16-6 terminal

2 pieces per set

2 red heat-shrinkable tubes

1 * Small black wire terminal in isolator

4 * Set screw


POLICES

 

We only ship to confirmed Paypal addresses. Please comfirm that your paypal address is in line with your shipping address.

 

Please kindly note that the combined shipping is not provided because the shipping fee is calculated by weight. Also, the each additional item means exactly the the same color and size. 

 

It takes about 7-15 working days to UK; about 10-30 working days to other countries. Transit time may be a little delayed because of the bad weather and customs inspection. If you do not receive your item within 30 working days since payment finished, please contact us immediately for further assistance.

 



We accept payment via Paypal only.

Payment must be completed within 5 days. If you have any problems about payment, please contact us via ebay message.


 

We strive for 100% customer satisfaction! Positive Feedback is very important to us. If you have any questions, please feel free to contact us via "Ask seller a question" . We will reply your email within 24 working hours.



DataCaciques