Description
Bond-It Flashing Tape Roll like Flashband
"Peel & Seal" Repair or replace your roof flashing!
High quality BITU-BOND Peel & Seal self-adhesive Flashing tape.
This easy to use, tough but flexible tape is suitable for general repairs and sealing use. It is weather proof and provides long lasting protection. Keep the water out! Available in popular 10 metres roll widths: 50mm, 75mm, 100mm, 150mm, 225mm, 300mm, 450mm & 600mm widths. Need to repair a small area? we also sell a popular repair kit option too.
Why buy BITU-BOND Flashing tape?
The strength of the facing gives resistance to puncturing and the bitumen gives flexibility and adhesion but without the problems of slump. Designed for use as flashing on flat and pitched roofs, roof valleys, parapets and chimney stacks. Also ideal for sealing around RSJ's, flues, concrete columns, roof-lights, guttering and extractor vents.
 | Replacement of worn Lead Flashing |
| Lead coloured - blends with existing lead |
| Crease resistant |
| Easy to apply |
Suitable for many uses and can be used on:
| Replacement or repair of flashing |
| Guttering, down pipes, skylights |
| Extensions, porches & chimneys |
| Caravans & Conservatories |
| Sealing parapets, valley gutters |
| Seals capping bolts & roof ridges |
| Roof repair of portable buildings |
Manufactured by Bond-It, a leading name in the production of sealants, adhesives, polyurethanes and more; Bond-It has an enviable reputation in the marketplace for quality and reliability, which is why they are chosen by Truly PVC Limited.
Technical Information
| Code | Width | Roll Length | Coverage |
| BDF 001 | 50mm | 10 metres | 0.5m2 |
| BDF 002 | 75mm | 10 metres | 0.75m2 |
| BDF 003 | 100mm | 10 metres | 1m2 |
| BDF 004 | 150mm | 10 metres | 1.5m2 |
| BDF 005 | 225mm | 10metres | 2.25m2 |
| BDF 006 | 300mm | 10metres | 3m2 |
| BDF 007 | 450mm | 10metres | 4.5m2 |
| BDF 008 | 600mm | 10 metres | 6.00m2 |
Fitting and Usage
Some brief guidelines for Bond-It BITU-BOND flashing tape...
Ensure all surfaces are clean, dry and dust-free. Remove any loose particles and any rust with a wire brush & soft broom.
The use of gloves is recommended.
Rough, porous or friable surfaces (such as wood, cement boards, course brickwork, breeze blocks etc..) should be primed with a bituminous primer and allowed to dry in order to improve bonding strength. (we sell primer in 1ltr 2.5ltr and 5litre tins)
- Roll out the flashing strip then cut to the required measured length
- Remove the backing paper (peel back 150mm) and place the adhesive side to the previously prepared surface
- To ensure a tight contact - smooth the tape down with a dry cloth, removing all the air bubbles
- Press the tape to the surface firmly once in position
- Repeat the steps 2-4 in 300mm to 600mm sections until the area is covered
- If the tape is joined ensure all overlaps are greater than 25mm
- Smooth flat all edges with a wallpaper roller or trowel
- After use reseal pack and store upright in cool, dry conditions
