Preparation of base: Protect elements not intended for painting. Next grind, degrease and dry the surface to be painted (do not use petroleum naphta for that). In 99% of cases it is sufficient to apply only one coat. If 2nd coat necessary - it needs to be applied with another item (new tin), to avoid wrong result. Please notice: Using brush doesn't leave marks, as product is dense, and goes on surface smoothly.
Intermediate grinding between layers is not required, if subsequent thin layer is able to being put on after min.24 hours. When used in capacity of renovation coating, the enamel can be applied directly on coatings showing good adhering properties, based on other two-component paints (polyurethane or epoxide), or directly on thoroughly degreased raw surfaces. The enamel can be spread by means of spray gun, roller (velours) or brush.                                                                                            

Method of use: The best results when painting in temperature approx. 20°C. Such temperature is optimal for good enamel drying. Drying time depends on air humidity and product density as well. Prior to starting of painting, thoroughly mix A and B cans components. It can be best done by pouring B can contents into A can, which intentionally has higher capacity in order to facilitate mixing of both components. Then allow approx. few minutes to enable the enamel (A can) reaction with curing agent (B can). Protect surfaces not intended for painting, then start spreading of the enamel. After being mixed, the preparation is ready to be used by 2-4 hours at 20°C. Use polyurethane solvents. After being mixed product is suitable for single usage only.