ELECTRIC 230V DAFI INSTANT WATER HEATER/BOILER UNDER SINK

7,3 KW

DAFI ORGINAL - MADE IN UE
This is the in line model which does not need wall brackets and reducers. It is designed to be hang of pipe. The package includes the heater, black single brass terminal, valve, wrench and two fibre washers.

THE DAFI INSTANTANEOUS ELECTRIC WATER HEATER IS A COMPACT,
ENERGY-SAVING AND CONVENIENT SOLUTION TO PROVIDING
INSTANT HOT WATER TO ANY POINT IN A BUILDING.
COMPACT SHAPE AND SMALL SIZE ALLOWS UNDER SINK MOUNTING.
CAN BE USED WITH STANDARD MIXERS & TAPS.

ELECTRIC ENERGY IS USED ONLY WHEN HOT WATER IS DRAINED OFF FROM THE TAP,
WHICH MAKES ITS POWER CONSUMPTION LOWER THAN IN THE CASE OF STORAGE-TYPE (TANK) WATER HEATERS.

THE DAFI WATER HEATER SUPPLIES HOT WATER IMMEDIATELY AFTER THE HOT WATER HAND WHEEL IS TURNED ON.

ITEM WEIGHT: 898 g
Product Dimensions: 16,1 x 9,1 x 8,6 cm
Voltage: 230 volts

PLEASE STUDY TABLE BELOW BEFORE YOU CHOOSE THE RIGHT POWER OPTION
 
BEFORE YOU BUY CHECK IF OBTAINED FLOW CORRESPONDS TO YOUR DEMANDS

FOR EXAMPLE:
 
DAFI 3,7kW heats 1.9 Litre of water per minute to 40°C
 
DAFI 7,3 heats 4 Litres of water per minute to 40°C
 
the minimum temperature of  flowing water 15°Cand pressure 0,2MPa / 2Bar
Each heater unit is to be wired to the Distribution Board via the existing Earth Leakage System.

Minimum 3 core cable sizes*
- 2.5mm² for 3.7 kW & 4.5kW (240V)
- 4 mm² or 2x2.5mm²(ring) for 5.5 kW & 7.3kW - (240V)
- 2.5mm² for 7.5kW these models is two phase no neutral -(400V)
 
DAFI water heaters must be installed as close to the point of use as possible to minimize pipeline heat loss.
Water pressure must not be less than 60kPa (0.6 bar) and not exceed 600kPa (6bar)

THIS PACK INCLUDES

1 x Water Heater
1 x Black Single Brass Terminal
1 x Valve
1 x Wrench
2 x Fibre washers

Dear customers
Please note that the next day delivery
apply only for orders placed by 1pm