You are bidding on one
3 Phase Brake Switch and Rectifier Combination Unit
Now with terminal block for easier connections
(can be used in single phase AC and DC applications)
Recommended for 12V applications
The kit comes with:
- 50 Amp, 3 phase wind turbine brake switch
- bridge rectifier
- heavy duty electro-galvanized steel recessed backplate
- all pre-wired and ready to go!
This switch will handle 2500 watts continuously. Rated at 10A at 250 Volts, 15A at 125v, 25A at 60v, 40A at 30V and 50A at 15V.Rectifier Specifications:
- Good cooling capabilities - can handle 50 Amps continuously using air cooling, no fan.
- Works on all AC output wind turbines that produce 50 Amps or less
- Operating range is 0 to 1000 Volts
Note: Use self tapping screws or the spade terminals to connect your wires.
Brake Switch Specifications:
50 amp, 3-phase switch with short circuit brake works with 12 volt to 250 volt systems. Designed for 1500 watt and smaller turbines.
Simple, yet perfect for small turbine installations, this 3-phase switch uses a specialized switch to provide both disconnect capability as well as braking by shorting out the 3 wires of the stator. Although designed specifically for 3-phase turbines it works equally well for single phase AC turbines as well as DC turbines.
Switch Positions:
- Up: Turbine is connected to the battery or rectifier (switch is closed).
- Middle: Turbine is fully disconnected (free spinning).
- Down: Turbine wires are shorted together (brake is on).
This switch will handle 2500 watts continuously.
Rated at:
- 10 Amps at 250 Volts
- 15 Amps at 125 Volts
- 25 Amps at 60 Volts
- 40 Amps at 30 Volts
- and 50 Amps at 15 Volts
Switch Positions:
*Label appearance may vary from product picture
- Up -- Turbine is connected to the battery or rectifier. (Switch is closed)
- Middle -- Turbine is fully disconnected, free spinning.
- Down -- Turbine wires are shorted together. Brake is on.
Just connect your wind turbine to the brake switch and that's it! Your charge controller will connect positive to positive (+ to +) and negative to negative (- to -) to the three phase rectifier!
Works with 12 volt to 250 volt systems
Designed for 1500 watt and smaller turbines.
Although designed specifically for 3 phase turbines, it works equally as well for single phase A/C turbines as well as D/C turbines.
For indoor use only
as best we can. Click here to visit our store for a full listing of our wind turbine and solar products! We do not mark items as gifts or under report values for customs. For International buyers, it is strongly recommended to check your own country's tax practices as we do not pay your taxes, duty or customs fees. We do not over charge for shipping; it is simply what the shipping calculator comes up with. Customs fees or taxes are not included in shipping, it is your responsibility to pay them. UPS orders ship signature required at our discretion!! Contact us right away if you need to make other arrangements!
|
On Aug-09-17 at 07:56:34 PDT, seller added the following information:
Mountain Wind Trading Co. provides a 90 day limited warranty on items manufactured in-house. Warranty covers workmanship and manufacturer defects. 90 day warranty begins at date of purchase and is non-transferable.
Customer is responsible for all shipping costs and must provide proof of purchase.
Warranty does not apply to:
Damage from marine use and/or saltwater environments
Corrosion due to saltwater air
Misuse
Faulty installation
Application outside manufacturer recommendations