This controller is for brushed (Also known as "PM" or "Magnet" motors)-
NOT FOR BRUSHLESS MOTORS
This is a awesome controller, durable and long lasting. For the price you can't go wrong and we use these on our custom builds so they WORK.
Be sure to check out our store for a wide selection of top quality scooter parts!
This comes normally wired like this but we can set it up to your needs in some cases and if you purchase our throttle at the same time,,any throttle,,we will set it up to plug right in.
2 wire connector red and black-Charger port
4 wire female connector black=Negative,red=1-5v to throttle,green=0-5v from throttle and Red with Black Stripe=48+volts(for display only)-Common 4 wire throttle with display
2 wire female connector black and yellow-Optional Cut off for brake switch for front or rear
2 wire female connector black and red-Optional brake lights
2 wire female connector red and blue-Power switch or key on/off
2 wire male connector red and black-Battery wires
2 wire female connector blue and yellow-Motor Wires
2 wire optional ground
..Remember--If you need a matching standard throttle,5 LED throttle or throttle with key or 1 of our digital display throttles with keys in anodized,blue,red or chrome,,simply purchase which one you want and It will come with a connector ready to plug in..If you order one of our throttles with keys your controller will have a 6 pin connector that combines variable throttle and on/off capability.
Under Voltage Protection | When battery voltage falls to a specified value, the controller cuts off battery output preventing over discharge and extending battery life.
(The cutoff value is approximately 30.5 volts, but varies drastically from controller to controller.) |
---|
Rated Voltage | 36 Volts |
---|
Rated Current | 31 Amps |
---|
Rated Motor | ≤ 1000 Watts |
---|
Rated Charger | ≤ 1.2-3.0 Amps |
---|
Conversion Efficiency | 95% |
---|
Under Voltage Protection | 30.5 Volts |
---|
Dimensions | 105 x 70 x 40 mm |
---|