x2pcs A3967 EasyDriver Stepper Motor Driver V44 for Arduino Development Board 3D Printer
- The EasyDriver is a simple to use stepper motor driver,
- compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver).
- EasyDriver requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor.
- The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3.3V.
- Connect a 4-wire stepper motor and a micro controller and got precision motor control!
- EasyDriver drives bi-polar motors, and motors wired as bi-polar. I.e. 4,6, or 8 wire stepper motors.
- On this version (v4.4) we fixed the silk error on the min/max adjustment.
- MS1 and MS2 pins broken out to change micro stepping resolution to full, half, quarter and eighth steps (defaults to eighth)
- Compatible with 4, 6, and 8 wire stepper motors of any voltage
- Adjustable current control from 150mA/phase to 750mA/phase
- Power supply range from 7V to 30V. The higher the voltage, the higher the torque at high speeds
Specifications:- Main color: Red
- Board size: 47 x 20mm
- Pin header size: 51 x11mm
- Net weight: 7g
Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC.
- The EasyDriver is a simple to use stepper motor driver,
- compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver).
- EasyDriver requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor.
- The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3.3V.
- Connect a 4-wire stepper motor and a micro controller and got precision motor control!
- EasyDriver drives bi-polar motors, and motors wired as bi-polar. I.e. 4,6, or 8 wire stepper motors.
- On this version (v4.4) we fixed the silk error on the min/max adjustment.
- MS1 and MS2 pins broken out to change micro stepping resolution to full, half, quarter and eighth steps (defaults to eighth)
- Compatible with 4, 6, and 8 wire stepper motors of any voltage
- Adjustable current control from 150mA/phase to 750mA/phase
- Power supply range from 7V to 30V. The higher the voltage, the higher the torque at high speeds
Specifications:
- Main color: Red
- Board size: 47 x 20mm
- Pin header size: 51 x11mm
- Net weight: 7g
Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC.
