This charge controller designed and assembled in England will
control 12V/600W wind generator (or less) and 12V/600W solar panels (or less)
in hybrid setup, effectively the charge controller will control up to 1200W.
When used with solar panels: regulator will
disconnect the solar panel(s) when batteries voltage will reach preset value
(cur. set at: 14.0 volts),
it will connect the solar panels to the batteries
again when batteries voltage will drop to 13.0
When used with wind generator only it will connect
dump load to the batteries when batteries voltage will reach preset value
(14.0V) then it will disconnect the dump load
when batteries voltage will drop to 13.0V.
When used in hybrid setup with wind generator and
solar panels it will disconnect the solar panels when batteries voltage will
reach preset value (14.0) and connect the dump load. When batteries voltage
will drop to 13.0 it will connect the solar panels to the batteries again and
disconnect the dump load.
Batteries voltage can be adjusted by the user.
In the package you'll get: 12V/600W charge controller, 12V/600W dump
load, all the necessary cables to connect the charge controller and the dump
load to the battery, 40 or 50A 3 phase bridge rectifier with the heat sink
attached (free of charge), if you prefer to install suitable heat sink to the
bridge rectifier by yourself please let me know.
This set can be connected to AC and DC wind generator, instruction
"how to connect" also included in the package.
Size and design of the charge controller box may vary.
12 months guarantee!