220v 120W Heater Pad Engine Block Hydraulic Tank Heating Plate Oil Pan Sump & EU Plug

 

 

https://ti2.auctiva.com/tia/0/snowmobilefire/descbtn.gif

 

 

Specifications
Material: Alloy wire,Silicone rubber
Color: Orange
Heater size: length:13cm width:9cm
Wire length: 210cm
Insulation material the highest resistance temperature: 220 degrees
Power error: 8%
Insulation resistance:≥5 MΩ
Compressive strength: 1500v/5s
Resistance voltage: 6KV
Power:220v 120w

Features
-Fast heating, uniform temperature, high thermal efficiency, high strength, easy to use, safe life for up to two years, not easy to aging.
-The silicon rubber heater can be used in the wet, non explosive gas environment, industrial equipment, pipelines, tank barrels with heat insulation (oil heater).
-Can be used as the auxiliary heating of the refrigeration and air conditioning compressor, motor and other equipment.
-Can be used as medical devices (such as blood analyzer, test tube heater, medical care, slimming belt corset heat compensation etc.).
-Well waterproof performance, fast temperature rising, temperature uniformity,High thermal efficiency, well toughness .
-Conform to the American UL94 level V0 flame resistant standard.
-Easy to use, safe service life for ten years, not easy aging.
-Can be directly tied to the surface of heated objects.

Using range: All kinds of automobile fuel tank, water tank, storage battery, anti-freezing heat insulation

Installation
-Use pressure-sensitive adhesive to stick it on the flat and smooth artifacts
-The maximum service temperature of pressure sensitive adhesive: 150℃ Continuous temperature, 220℃instantaneous temperature. Power density is less than 0.9 W/c ㎡
-Silicone rubber heater with pressure sensitive adhesive should be used in half a year after processing, otherwise it will influence on the performance of the glue using

Instructions
-The electric heating device must pay attention to use, its working temperature should be less than 220 ℃, the continuous use instantaneous does not exceed 220 ℃.
-when the work temperature less than 220 ℃, the current density is up to 3 w/c ㎡
-Paste the type installation conditions, allowed working temperature less than 150 ℃
-Working voltage selection with high power high voltage, low power low voltage for the principle, special needs can be exceptions.

Package Included
1 x Heater Pad
Note:
Please allow 1-3cm error due to manual measurement and make sure you do not mind before ordering.
Please understand that colors may exist chromatic aberration as the different placement of pictures.
(other accessories shown in the pictures are NOT included,just for effect illustration.

 

https://ti2.auctiva.com/tia/0/snowmobilefire/paybtn.gif
https://ti2.auctiva.com/tia/0/snowmobilefire/shipbtn.gif
https://ti2.auctiva.com/tia/0/snowmobilefire/termsbtn.gif
https://ti2.auctiva.com/tia/0/snowmobilefire/aboutbtn.gif
PushAuction