R&G HEATED GRIPS 22mm or 7/8 handle bars only

5 Adjustable heat settings so you can optimize the heat output to suit your needs

12v Direct from Battery with Relay on an ignition circuit is recommended so you don't kill your battery

between 35 - 60 degrees heat after 3 minutes ( left grips will always be cooler initially as it is direct to bar so takes a little longer)

RIDE BEST BUY AWARDED !

YAMAHA TDM 900 2- R&G Racing Hot Heated Grips 22mm 7/8 Handlebar To be fitted by experienced Mechanic

Purchasing means you have checked you have 22mm bars / clip ons - Test the function and 5 heat settings before fitting. The lower heat settings works after 5 minutes of use on the highest setting with bike engine running only. The heat produced on lower settings it to maintain and won't be felt if you have not pre-heated the grips.

Do not twist or cut more than 5mm off the grip - Open ended grips 124mm long +/- 1mm to fit with most bar ends. Not suitable for throttle tubes that have nocks or raised areas. Your bike being listed is NOT a gaurantee this UNIVERSAL products will fit many people fit renthal bars or aftermarket bars so theres a good chance you will have no issues. Please use common sense. As a universal product some minor modifications or depending on how you fit some small additional electrical connections or wire maybe required seperately. No two bikes are the same so please accept some effort may be required to make it fit as you like. It is a 12v product - low capacity bikes 50cc -125cc may not cope with the output of 4amps please only buy if your sure your bike will be ok and check before ordering. (Particular issues have been raised with some bmw / Harley and aprilia fitments but only a small handful)