KADA 853B 220V Preheater Preheating Station
product manual:
KADA853B hot air preheating station with rapid heating, continuous and reliable, hot and cold air self-selection and so on
First, KADA-853B preheat Taiwan Features:
1. The use of advanced quartz infrared heating body heating fast, high efficiency, dedicated IC can accurately control the temperature range can be set at 100 degrees -380 degrees
2. Built-in temperature sensor, temperature and real temperature digital tube display.
3. Speed heating, just ten seconds up to 380 degrees
4. With 850D, 852d + hot air and Taiwan and 942,936 anti-static soldering station to use, on the large chip class (BGA), etc. with the characteristics of demolition welding fast;
5. Compact appearance, easy to carry.
Second, use
1. For electronics, electrical appliances, electric fast, maintenance, etc. PCB board industry, preheating / heating / component desoldering
2. For heat shrinkage, drying, paint removal, in addition to stick, thaw, warm-up, disinfection, welding.
3. Blowing tape plastic components, vibration device, the tail plug inserted within the seat is not deformed, blowing wire does not blister, remove the shield does not change color, blown BGA chip is not easy to break.
Third, the basic parameters
Model: 853B
Input voltage: 220VAC, ± 10%, 50Hz ~ 60Hz
Power consumption: 220V / 540W
Temperature range: 100 ℃ ~ 380 ℃
Air volume: 0.18mm per minute (tuyere)
Dimensions: 140X60X170mm
Weight: 1KG (without power cord)
Fourth, the use of:
1. Set to be processed PCB board components in the central air outlet. According to the size of components, circuit board thickness, PCB board tin melting point, set temperature (note the temperature setting is very important to master, or likely to cause PCB damage, the temperature should not be too high, otherwise PCB board deformation , Severe will be scorched, otherwise the temperature is too low will not take down the components).
2. Turn on the power switch and heating switch, the temperature rises and quickly reach a constant, when the component pin melting point of the solder, the components removed.
Note: So when the PCB board of the components of the pin tin points are in the vicinity of the melting point, then please do not immediately remove the PCB board, you should first turn off the heating switch, the machine blowing cold air to be on the PCB board temperature drop To room temperature.