Step 1.
Unpack all of your graphics and lay them out on a clear surface- the floor is always a good option. Now, seperate all of the graphics into order of location. So, a pile of Bonnet Graphics, Rear Graphics, Left side Etc.
Your vehicle should be clean and dry. If not, please do this before starting. Next, you need to clean the area you are applying graphics to with soapy water.
Step 2.
Place two pieces of masking tape to each end of the graphics you are applying and tack to the surface, roughly in position.
Step 3.
Using a tape measure or ruler, measure the graphic to the correct position.
Step 4.
Once the graphic is in position, place a strip of masking tape accross the top of the graphic - making sure it covers the whole width of it.
Step 5.
Slowly start peeling off the backing paper, making sure the graphic does not touch the surface until you are ready to apply.
Step 6.
Whilst still holding the graphic away from the surface, use your other hand (with a squeegee or credit card) to start applying the graphic. Use a steady left and right motion whilst slowly moving down the graphic- keeping a firm constant pressure with the squeegee/credit card.
WE RECOMMEND YOU DONT WASH THE AREA FOR AT LEAST 10 DAYS
** WE CANT TAKE ANY RESPONSIBILITY FOR ANY INCORRECT FITTING **