Technically correct for 1966 A-body year.

This is a NEW complete radiator – NOT a rebuild.  Correct new side mounting brackets and petcock at the bottom.  This is for a 4 speed – NON A/C car and is considered a Normal duty 2 row radiator.  It measures 17-1/4” tall x 22” wide x 1-1/4” thick.  This is just like the originals – just no Pentastar or Chrysler part numbers on the top of the tank.  Copper / Brass construction as again originals were.  Built for long performance and life.  With the cost of copper lately, this is way below today's retail price as it was made before the major copper increase occurred in the market - so get a new radiator at 2020 wholesale prices...

Please take note to your hose locations on your vehicle to where these are located no the upper and lower tank.  The picture is showing the radiator as if it was pointing towards the engine - so the upper hose is to the passenger side of center and the lower hose location is on the far passenger side.  Be sure to check these locations to where your water pump is pointing (passenger side in this case) and the upper hose location.

This radiator can also be made to fit for 1967 to 1969 A-body Mopars V8 or slant-six.  Only issue is the mounting holes on the side brackets - top two holes - one of drivers side and one on passenger side - the holes will need to be drilled on the flat mounting surface side bracket on these new tanks to match up to holes on the Radiator support.  So other than that - it will also fit those vehicles - Plymouth Valiant, Plymouth Barracuda, or Dodge Darts for 1967-69 years.

Factory specs for 1967-69 are 17-1/4" x 22 x 1-1/4".  So again you can see it matches up to the specs for 1967-69 - its just the pre-drilled hole location on the tanks side brackets that have to be altered with a simple new drilling of holes.

This is Made in the USA radiator - not a China junk one...