IS300 01-05 Gauge Pod Steering Column Passenger

This 3D printed part goes on the steering column cover. Designed to fit a 52mm or 2 1/16 gauge. This will work on any IS300 01-05 or IS200 99-05. The pod is designed so you can see as much of the cluster as possible, tilt the steering wheel up down and use the turn signal. The gauge pod is pointed straight forward and directly in the driver's peripheral vision. This fits on the front half of the steering column cover and every design follows the contours of the steering column cover for a clean look. I model all my designs from OEM parts to get the best possible fit. If this design does not work for you I have many other styles in my store.

This does not come with gauges, interior trim or hardware. This listing is only for the 3D printed part or hardware.

Installation is simple. You remove the cluster trim and the steering column cover and drill holes in the steering column cover with the supplied template. Each gauge pod is held in place by two bolts that go through the steering column cover. I recommend using M4x10 bolts,M4 nut and a washer for proper fitment. Once installed you can't see any of the hardware. Every pod comes with a drill template for proper placement.

I designed this with a 52.5mm hole for the gauge. Not all gauges are 52mm be sure to test fit your gauge DO NOT JUST PRESS IT IN. If you feel heavy resistance inserting the gauge the design will need sanding or you have a gauge larger than 52mm. Gauges are designed to fit snug so you don't have any rattles or noises. I've found that the lower end gauges are either larger or smaller than 52mm. If your gauge is loose add a layer of tape until it fits.

Made out of ABS plastic the same material most of the interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.

I have many other designs for the IS300. If you don't like this one, take a look at some of my other designs.