The white WP-572 Active 1-Gang Wall Plate HDMI over Twisted Pair Receiver from Kramer is a DGKat twisted pair receiver for HDMI signals. The WP-571 (not included) converts an HDMI signal to a single twisted pair signal and the WP-572 converts the twisted pair signal back to an HDMI signal.
The receiver supports a maximum data rate of up to 4.95Gb/s. DGKat twisted technology converts TMDS as well as control and communication to signals that run over twisted pair cables. EDID PassThru passes EDID signals between the source and display. A single connection to the transmitter powers the receiver.
Maximum data rate of up to 4.95Gb/s (1.65Gb/s per graphic channel)
HDTV compatible
HDCP compliant
DGKat Signal Integration technology converts TMDS as well as control and communication to signals that run over twisted pair cables
HDMI Support - x.v.Color, up to 7.1 uncompressed audio channels
3D pass-through
System Range - Up to 295' (90m) at 1080i, or up to 98' (30m) at 1080p on shielded BC−DGKat524 cable
Up to 295' (90m) at 1080i, or up to 230' (70m) at 1080p on shielded BC−DGKat623 cable
Up to 330' (100m) at 1080i or up to 295' (90m) at 1080p on shielded BC−DGKat7a23 cable.
Up to 295' (90m) at 1080i, or up to 230' (70m) at 1080p on shielded BC−DGKat623 cable
Up to 330' (100m) at 1080i or up to 295' (90m) at 1080p on shielded BC−DGKat7a23 cable.
Requires shielded twisted pair (STP) cable
Note:
Transmission range depends on the signal resolution, graphics card and display used. The distance using non−Kramer CAT 5, CAT 6, and CAT 7 cables may not reach these ranges. Use only shielded cable where both ends of the shield are soldered to ground.
EDID PassThru passes EDID signals between the source and display
ON LED - Lights red when receiving power only, orange when either input or output and power are attached and green when both an active input and output are attached
Single connection to the transmitter powers the receiver
1-gang US wall plate
Used in board, conference, and training rooms, presentation systems, signal distributions and home theater
Kramer WP-572 Specs
| Inputs | 1 DGKat twisted pair on a RJ−45 connector |
| Outputs | 1 HDMI connector |
| Bandwidth | Up to 4.95 Gb/s data rate (1.65 Gb/s per graphics channel). |
| Compliance With HDMI Standard | Supports HDMI and HDCP |
| Power Consumption | US: 12 VDC, 190 mA (single device); 360 mA total (when one device supplies the power to both devices) |