This 3D printed part goes in the driver dash vent. Designed to fit a 52mm or 2 1/16 gauge. This replaces the front part of the vent and still allows some air flow. This will work on any second generation GS300, GS400 or GS430 it will not work on any other cars.
This listing is only for the 3D printed part. It doesn't come with the gauges or any interior trim.
Installation is simple. You remove the front of the vent trim and take apart the back of the vent and replace the front with this. You reuse the top fin, bottom fin and one side trim piece(you won't see this until you take it apart). I was able to get the front vent trim off without removing the dashboard. You can get the front of the vent off with trim removal tools. I also removed a few of the lower dash panels to make it easier. No cutting or modifications are required to install.
I designed this with a 52.5mm hole for the gauge. Not all gauges are 52mm be sure to test fit your gauge DO NOT JUST PRESS IT IN. If you feel heavy resistance inserting the gauge, the design will need sanding or you have a gauge larger than 52mm. Gauges are designed to fit snug so you don't have any rattles or noises. I've found that the lower end gauges are either larger or smaller than 52mm. If your gauge is too loose add a layer of tape until it fits.
Made out of ABS plastic the same material most of the interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.
I have many designs for the second generation GS. If you don't like this check out the rest of my designs!
If you have any questions just ask!
Lexus GS300 Toyota Aristo V300 Gauge Pod Ash Tray/Lighter
Lexus GS300 Toyota Aristo Gauge Pod Vent
Lexus GS 99-05 Gauge Pod Cup Holder
Lexus GS300/400 Garage Opener Gauge Pod
Lexus GS 99-05 Gauge Pod Ash Tray