RSX 02-06 Vent Gauge Pod Vent 52mm

This 3D printed part replaces the front of the vent to run an aftermarket 52mm gauge. Designed to fit a 52mm or 2 1/16 gauge. It will work on any 02-06 RSX. It will not work on any other vehicle. This will work on any of the vents. This design has a smooth front face that matches the RSX interior well. I model my designs from OEM parts to get the best possible fit. 

This does not come with the gauges or any interior trim it only comes with the 3D printed part. 

Installation is simple and requires basic hand tools. If you have an analog gauge with a larger depth you may need to trim inside the vent for clearance. Once you remove the interior trim you replace the front fins with my design. Go slow when removing interior trim, the trim on the driver vent is very brittle and can break very easily. The driver vent will come out with two screws on the back. The front of the vent will come off by prying back four tabs. Again go slow they can break very easily. When you have the front of the vent off you remove the front  and back fins and snap the new design in place. 

I designed this with a 52.5mm hole for the gauge. Not all gauges are 52mm be sure to test fit your gauge DO NOT JUST PRESS IT IN. If you feel heavy resistance inserting the gauge, the design will need sanding or you have a gauge larger than 52mm. Gauges are designed to fit snug so you don't have any rattles or noises. I've found that the lower end gauges are either larger or smaller than 52mm. If your gauge is loose add a layer of tape until it fits.

Made out of ABS plastic the same material most of the interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.

I have many other designs for the RSX. If you don't like this one, take a look at some of my other listings. Thanks