This listing is priced per roll

Roll size is 67.5CM X 4M

BRAND NEW D C FIX WASHABLE WIPEABLE WALLPAPER TO COVER SMOOTH WALLS OR EXISTING TILES

extremely durable wallpaper can be applied in wet areas, just remember to seal all the edges using silicone sealant.

This wallpaper is meant to run across the wall and not down, so perfect as a kitchen splash-back where you'll have a continuous design and no annoying joins for 4m

• 
  
• 3D effect
• 
  
• Washable
• 
  
• Suitable for wet areas
• 
  
• Seal edges and joins
• 
  
• Durable
• 
  
• Realistic printing & designs
• 
  
• Design runs down the roll not across
• 
  
• Ideal splash-back solution over tiles
• 
  
• Glue required over tiles which we also supply

1. 
   
2. Preparation of under-surface and individual sections

Surfaces (tiles or walls) should ideally be smooth, solid, dry and free of cracks and holes. Any uneven areas must be corrected by the use of appropriate filling material (e.g. Metylan surface filler for absorbent under-surfaces).

Cut the first strip from the roll by placing the beginning of the pattern at the top and allowing a slight overlap at the bottom.

1. Application of adhesive

For absorbent under-surfaces, such as cement or plasterboard, use a normal commercial wallpaper paste for heavy-grade wallpapers (e.g. Metylan Special). Apply the paste to the cut strip, fold it together and allow it to absorb the paste for about 10 minutes.

For non-absorbent under-surfaces, for example oil-treated or painted areas, use normal commercial dispersion adhesive (e.g. Ovalit S). Moisten the rear surface of the strip with water, allow it to soak in for about 10 minutes and then apply the adhesive to the wall over the area intended for the cut strip.

You should always follow the application instructions provided by the adhesive manufacturer.

1. Application of wall covering

Apply the first strip, starting at the top, and ensure vertical alignment. Cut the next strips so as to ensure the alignment of the tile pattern, with the necessary overlap at top and bottom, and place it next to the previous strip after applying adhesive. Avoid the need to make joins in the corner the rooms.

Attention: Immediately remove any spots of adhesive with clean water!

1. Sealing

In particular in rooms which are subject to moisture, it is essential to ensure that all edges and joins are selaed with PVC cold welding paste (for PVC wall coverings). This prevents moisture from penetrating underneath the wall covering.

When finished, ensure that the room is well ventilated!

1. Cleaning and care

Ceramics is completely waterproof. It is therefore easy to undertake cleaning and maintenance. The cleaning can, for example, be carried out with mild liquid commercial cleaners, soapsuds or similar. Afterwards, always wash the wall covering thoroughly with clean water.

Warning: Always avoid contact with acetone, cleaning solvents and direct heat!

1. Replacement

Even many years later, it is easy to remove the PVC surface by separating it from the support paper at an upper or lower corner and pulling it in its dry state from the backing. The paper layer which remains stuck to the wall is an ideal under-surface for a subsequent wallpapering activity.

NOTE: WE CAN ALSO PROVIDE New Extra-Strong Wallpaper Paste £2.50 A BAG