THIS IS REPAIR SERVICE!

Please read description carefully and do not complete purchase unless you agree with all terms!

Repair service for Amp block from Velodyne subwoofer speaker. 

Please carefully take your unit apart, disconnect two speaker wires and  accelerometer connector from input board, shown in picture.

Make sure to take some photos before disconnecting them to ensure right orientation following assembly. Failure to do so might damage driver(speaker)

 Do not send whole unit.

Please do not purchase without checking with me first if there is any repair attempted to your block or presence of physical damage.

Also, be advised, if there is an issue with accelerometer sensor that is located inside of driver (speaker) your unit will experience distortion in sound. In which case I can not accept returns or refunds, since work on amp board is already done.

When you purchase this part, if you need it,  you will also get full technical support!

Service is covered with 1 year warranty

    IMPORTANT SAFETY NOTICE !!!

This service part is intended for use by persons having electrical, electronic and mechanical experience and knowledge at level generally considered acceptable in the consumer electronics and appliance repair trade.

Any repair attempt may result in personal injury and property damage.

I cannot be responsible nor assume any liability for injury or damage of any kind arising from use of this part.