G35 03-04 Triple Gauge Pod Angled Cubby

This 3D printed part replaces the cubby to run three 52mm gauges. The pods fit a 52mm or 2 1/16 gauge. It will work on any G35 03-04. It will not work on any other car.  The design screws into the factory mounting spots cubby and doesn't require any cutting or drilling.

This listing is only for the 3D printed part. It doesn't come with the gauges or any interior trim.

Installation is simple and requires basic hand tools. Remove the radio/climate control trim then remove the cubby with the two screws. Install the part and reuse the factory hardware.

I designed this with a 52.5mm hole for the gauge. Not all gauges are 52mm be sure to test fit your gauge DO NOT JUST PRESS IT IN. If you feel heavy resistance inserting the gauge, the design will need sanding or you have a gauge larger than 52mm. My gauge pod designs are meant to fit snug so you don't have any rattles or noises. 

Inexpensive gauges are either larger or smaller than 52mm. If your gauge is too loose add a layer of tape until it fits.

Made out of ABS plastic the same material most automotive interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.

I have many other designs for the G35 if you don't like this one.

If you have any questions just ask!