Product Features:
CH32V103R_MINI development board, applied to the development of CH32V103 chip.
IDE using MounRiver compiler, can use WCH-Link for simulation and download.
CH32V103 is a general-purpose microcontroller with a 32-bit RISC-V instruction set core, featuring fast interrupt response and low power consumption design.
Integrated rich peripheral resources include: USB2.0 host/device controller, multiple touch key detection (TouchKey), DMA controller, 12-bit ADC, RTC, 7 groups of timers, multiple I2C/UART/SPI and other common communication interfaces, which can meet the needs of motor control, sensor acquisition, health care, consumer electronics and other market applications.
Product parameters:
Button S2:Reset button
Debug interface: for downloading, simulation debugging
Start-up configuration mode:Select the start-up mode when the chip is powered on by configuring BOOTO/1
USB-A port: the main chip's USB communication interface, with Host and Device function
TYPE-C port: the main chip's USB communication interface, with Host and Device functions
Power Indicator
LED1, LED2 cathode pins: can be connected to the chip IO port through the Dupont wire inlet for control.
Application areas:
Can be widely and quickly applied to, industrial control, medical and health equipment, security and monitoring alarm, micro printer reader
Security and lighting and other products that require voice control
Development environment:
IDE use - MounRiver
Download MounRiver_Studio, double click to install it, and then you can use it.
Please refer to the official document of Qinheng Microelectronics for the development routines and IDE instructions.
Download Instructions:
WCH-LINK Download
To use this method, you need to have WCH-LINK downloader, which can be downloaded online for debugging and easy to use.
To use WCH-LINK, you need to install the MounRiver IDE first, then install the usb driver, the driver path is in MounRiver\MounRiver_Studio\LinkDrv\Link:
Connect the CLK, DIO, GND, 5V pins of the development board and the downloader using DuPont cables.
Open the MounRiver software and add the project. After recompiling correctly, click the drop-down menu next to the download button to download the configuration. Unprotect the chip from read protection and you can burn the chip.
1 is to check the chip read protection status;
2 is to set chip read protection, re-power the configuration to take effect; 3 is to release chip read protection, re-power the configuration to take effect;
WCHISPTool download, use this way only need a usb to typec cable can be burned through the USB program.
USB pin PA11(DM),PA12(DP),serial pin PA9(TX),PA10(RX).
The download process is:
1. BOOTO connected to VCC, BOOT1 ground, connected to the PC through the serial port or USB; 2. Open the WCHISPTool tool, select the appropriate download method, select the download firmware, check the chip configuration, click download;
WCHISPTool tool interface as shown in the figure
Package include:
CH32V103R MINI development board + pins