DIY kit features:
Through-hole components
RJ-45 connectors for DMX input and thru
Small 2.4" x 3.6" footprint
Operates on 8 - 20 VDC
Separate power connections for servo power
DMX address selection using DIP switches
Select any of 511 DMX addresses
LED for power status
DMX network terminator jumper
Optional servo hold/release in the event of DMX signal loss
Solder points for wiring an external DMX connector
ROHS Compliant

This is a DMX512-A servo kit using ANSI approved RJ-45 connectors for DMX networks. This kit is designed to receive any DMX packet size and never fail to precisely control the servo's. Power requirements for the electronics are 8 - 20 Vdc @ 50 ma. Power requirements for servo power depend on your supplied servo's. The board features an indicator LED for power, screw terminal blocks for electronics power and servo power connections, solder points for hard wiring a external DMX connector, dip switch for DMX address selections and jumpers for termination and options. Also available assembled and tested, check out my other items or email for more information.

->> Assembly Manual <<- in PDF format, if Ebay removed the link, sorry but you'll have to search for "KDS00801" on the internet for assembly manual.

• 1 - High Quality PC Board
• 1 - Atmel Micro-Controller IC
• 1 - SN75176 Bus Transceiver IC
• 1 - 78L05A Voltage Regulator IC
• 2 - 74HC126 Buffer IC
• 1 - 1N4002 Diodes
• 2 - 220ufd Electrolytic Capacitors
• 5 - 0.1ufd 50v Ceramic Capacitors
• 1 - 1.5k ¼ Watt Resistor
• 1 - 120 ohm ¼ Watt Resistor
• 1 - DIP Switch 9-Position

• 2 - 20-Pin IC Sockets
• 2 - 14-Pin IC Sockets
• 1 - 8-Pin IC Socket
• 2 - RJ45 Jacks
• 1 - LED
• 1 - Spacer for LED
• 2 - 2 Position Terminal Blocks
• 8 - 3 Pin Headers
• 1 - 6 Pin Header
• 3 - Header Jumpers
• 4 - PCB Standoffs

• Good quality soldering iron 25 – 40 watt
• Solder tip cleaning sponge

• Rosin core or no clean solder
• Diagonal wire cutter