RSX 02-06 Gauge Pod Steering Column Passenger

This 3D printed part mounts on the steering column to run an aftermarket 52mm gauge. Designed to fit a 52mm or 2 1/16 gauge. It will work on any 02-06 RSX it will not work on any other car. The listing is only for the 3D printed part it does not come with the gauge or any interior parts. The gauge pod is pointed straight ahead directly in the driver's peripheral vision. This fits on the top of the steering column and follows the contours of the column cover for a clean look. The design can be put in the center, left center or right center of the column cover.

Drilling into the steering column cover is required to install this. The pod mount has threaded inserts in the design to mount the hardware. The design comes with a drilling template and hardware to make installation easy.

This does not come with the gauges or any interior trim it only comes with the 3D printed part. 

I designed this with a 52.5mm hole for the gauge. Not all gauges are 52mm be sure to test fit your gauge DO NOT JUST PRESS IT IN. If you feel heavy resistance inserting the gauge, the design will need sanding or you have a gauge larger than 52mm. Gauges are designed to fit snug so you don't have any rattles or noises. I've found that the lower end gauges are either larger or smaller than 52mm. If your gauge is loose add a layer of tape until it fits.

Made out of ABS plastic the same material most of the interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.

I have many other designs for the RSX. If you don't like this one, take a look at some of my other listings.

Any questions just ask!