Description:
Acrylic Case
Material: Acrylic
Color: Transparent
Size: approx.83 x 83 x 30 mm
For DIY mega328 Transistor-tester
Package Included:1PC*Acryl Case for GM328 Transistor Tester(DIY Kits)
Mega328 Transistor Tester （DIY KITS）

Color: as picture shows
This item is DIY kits, need solder it by yourself
The use of SCM ATMEAG328P DIP-28. With IC Block
The display unit using a 160x128 pixel color display, full-screen characters 8x20, 16-bit color depth, graphic display element symbols
Rotary switch control, a key measurement, automatic shutdown
Use 9V laminated battery, can also use the power adapter(DC 6.8-12V), the whole current of about 30mA, after about 20nA shutdown current
Automatically detects NPN and PNP transistors, FET, diodes, dual diode, thyristor, SCR, automatic identification of the transistor pin out
Test NPN and PNP transistor common-emitter current amplification factor, the base - emitter threshold voltage, off the collector - emitter leakage current
Pole through the transistor base - emitter threshold voltage and high current gain recognition Darlington transistor
Detecting power transistor and FET protection diodes built
Test FET gate - source threshold voltage is turned on, the drain - source on-resistance, the gate - source capacitance
A maximum of two measuring resistors, so three feet adjustable resistor can be measured, if adjustable resistor is transferred to the end, can only be a measured resistance value
Resistance measurement maximum resolution 0.01Ω. Can be measured up to 50MΩ
Capacitor measuring range from 25pF-100mF, Resolution 1pF
Larger than 90nF capacitor while measuring its equivalent series resistance (ESR), the equivalent series resistance of the highest resolution of 0.01Ω
Larger than 5000pF capacitor also showed the rate of decline after the charging voltage of the capacitor value can reflect the quality factor (Q value)
Measuring a maximum of two diodes show its positive and negative, on-state voltage LEDs also display a graphic symbol diode, the conduction voltage is much higher than ordinary diode
Reverse breakdown voltage is lower than 4.5V Zener diode can detect it, appears as double diode symbol. Its positive and negative voltage to turn around 700mV diode symbol prevail, a second diode symbol corresponding to the voltage is turned on regulation. So do not be an ordinary diode and a Zener diode were measured simultaneously
Test a single diode, while its test reverse junction between the PN junction capacitance between the PN junction capacitance of the transistor to be tested, then only at the same time into the transistor base and the emitter, base and collector or
Of less than 25pF capacitor to be tested, the test need to prepare a 30pF capacitor, 30pF capacitor to test, test and then measured again after the capacitor connected in parallel, by subtracting the measured value 30pF capacitors with the results obtained
For the following 2100Ω resistor while measuring its inductance measuring range from 0.01mH - 20H
About two seconds during the test, large capacitors and inductors will take longer
Additional features include a frequency measurement, voltage measurement, square wave generator, PWM generator, color selection, commissioning calibration, continuous testing, and other functions
Frequency range from 1Hz to 1MHz or higher, measured at frequencies below 25kHz, can display period resolution to 0.001mHz
DC voltage measurement up to 50V
All the way to the square wave signal output, multi-range frequencies to choose from, the maximum output frequency of 2MHz
Output one fixed frequency, variable duty cycle pulse signal (PWM), the duty cycle is adjustable from 1% -99%
Separate capacitive function test, the test mode for the continuous measurement of 2uF-50mF capacitors can be measured directly in their circuit (circuit where the measured capacitance required power, after the measured capacitance required to be fully discharged)
Thyristors and thyristor can only recognize its pinout, and also need to test the thyristor or SCR trigger current is less than the current test instrument can provide, the tester can only provide a maximum trigger current 6mA
Function:
Switch off
Transistor test
Frequency test
f-Generator
10-bit PWM
C+ESR@TP1:3
continuous measurement resistance
1-||-3 continuous measurement capacitance
Rotary encoder
SelfTest
Voltage test
FrontColor
BackColor adjust
Show date
Note:Item color displayed in photos may be showing slightly different on your computer monitor since monitors are not calibrated same
Package Included:
1PC*tester DIy kits
  • We accept PayPal only. But we only Accept your Ebay Address,Please Make sure it's 100% right.
  • Payment must be received in 5 business days of auction closing.
  • Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
  • Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.

Fill your shipping info

  • All package need to wait 30 days(US only need 7-10 days),Please take care it.Less than 30 days,we can't take a refund.
  • If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
  • If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.

DataCaciques