Video https://youtu.be/Zl0TYoJ9NDI

Husqvarna PG 280, PG 450 And PG 530 Power Supply L6-20R No Generator Required 71108102
Power Cord Adapter Inverter (Reverse Converter) Takes two 115 volt outlets and allows you to use 230 volt appliances that uses under 20 amp @ 230 volts (4600 watts) Single phase current to NEMA L6-20R receptacle. Fast and Easy 220 volts.

Commonly used with:

Werkmaster Edge 000-0145-00 Concrete Grinder
Husqvarna PG 280 and PG 450 grinder 967648605
Husqvarna PG 530 grinder 965195814 is now a L6-30 and no longer in this grouping
Husqvarna S36 vacuum
Husqvarna DM340 Drill Motor
Husqvarna DC 3300
Lavina Elite L14EU Grinder
Lavina Elite L16EU Grinder
Lavina Elite L20E Grinder
DiamaPro SVX3-A-220 Dust Collector
Diamatic BMG-300 Grinder 240 V Single Phase 1622-5450 155242
Edco Turbo TMC-7 Mogno Trop Grinder 7 Cup 230 Volt 43569 35215
Techtogda 239420 Grinder 738629500303
Hypervac Hybrid Air Duct cleaning Machine
Bulldog 65008 Curing Machine
Blastrac 1-8DEC 230v
Blastrac BDC-23 970553003 230v 13 amp Single Phase
Blastrac 1-8DPS30 970554201 230v 16amp Single Phase
Blastrac 1-8DPF40 970554101 230v 16amp Single Phase
Diamatic 1622-5450 Grinder
General Equipment SG24E3HP60M 230 Volt Power Supply

Please check the NEMA number on your plug as Husqvarna has changed plugs a couple of different times over the years.

Many not fit all versions.

Bundled package includes:

Husqvarna PG280 PG450 PG530 DM340 Power Supply L6-20R Bundle No Generator Required 71108102
- Extended Warranty + No Extended Warranty
- Shipping Surcharges + Signature Required On All Deliveries

Extension Power Cord 230 Volt 50 ft 10 gauge 3 wire 10-3 with ends installed L6-20 P and R Not E351 20171017 Husqvarna Ginders

NEMA L6-20P Plug for 10 and 12 AWG Wire

tesla and electric car charger converter

Also used for electric cars, pressure washers, welders, plasma cutters, vapor steam cleaners, mobile simulation lab (RN), and other high powered equipment when 240 volt plugs are just not available.

Not for use on GFCI or LDCI 115-125 volt Outlets (because it will trip)

To use simply plug into different outlets and push the momentary button to test voltage. If the voltage test light turns on you are good to go. Not all outlet combinations will produce the correct voltage so you have to test before each use. If you push the voltage test button and the green light does not turn on, simply re-located one of the power cords to a different location and retest. Every job site location has the ability to provide plus or minus 240 volts. If you use 15 amp 115 v to 120 volt circuits then you will only be able to operate 15 amp 230 volt equipment. If your pressure washer needs 23 amps @ 230 volts and you are plugged into 20 amp 115 volt outlets, you will need to turn the pressure down to lower the amp draw. Just turn the pressure regulator / unloader knob counter clockwise. The less pressure, the less horse power is needed to turn the electric motor and this will lower the amp draw. Most 230 volt pressure washers draw less than 20 amps @ 230 volts any way so usually you will not have to turn the pressure down.

Commonly used the the Hypervac Hybrid Air Duct cleaning Machine.

Until both 120 volt power cords are connected to a 120 volt electrical source, it is electrically isolated from the electrical circuit of the male plug on the 2nd power cord. This protects the user from accidental shock through the male plug contact.

Plastic Box is 6" X 6" X 5"
Dual 12-3 X 25 ft power cords with dual 20 amp push breakers.
240 volt Green Test Light with Momentary switch.
Rubber feet on bottom of box

You must test both wall outlets with a receptacle polarity tester before use!

20100823

Factory Provided
Electrical Outlet Receptacle Tester 3 wire 120 volt

Note: User assumes all responsibility on use. It is the users responsibility to check the inbound voltage, outbound voltage, and total amp draw to verify these are not going to be overloaded. The user agrees to test the amp draw of any appliance or machine that they plug into these converters to ensure they are not being overloaded. Meters are cheap and mistakes are expensive. You can purchase a meter at https://www.steam-brite.com/voltage-meter-mulitester-p-6259.html
User agrees to hold Steam Brite, its employees, and agents harmless in the event of any use of said use of converter. The user agrees to not hold SteamBrite and all employee against any problems that arise out of the use of said converters/ inverters. Remember, just because it plugs in does not mean it is OK to use!

Please remember the 80/20 electrical rule. If you are going to plug into a 15 amp outlet and draw long term the device needs to be under 80% of 15 amps = 12 amps max.
If I plug into dual 20 amp breakers long term then the 80/20 rules math is 20 amps X 80% = 16 amps max.

Can be used on the Bulldog 65008 Curing Machine.
Compare to current or past OEM associations:
540-0213-00
Mytee 5008 Hunter

What Video at Https://youtu.be/Zl0TYoJ9NDI