Instructions:

1. Prepare the Surface:

   • Ensure the surface where you plan to apply the sticker is clean and dry.
   • If needed, use a mild cleaning solution to remove any dust, dirt, or grease. Allow the surface to dry completely.

2. Gather Tools:

   • Have a credit card, squeegee, or any flat, smooth object on hand. This will be used to smooth out the sticker and remove air bubbles.

3. Peel the Backing:

   • Turn the sticker over so that the adhesive side is facing up.
   • Gently peel back a small portion of the backing, exposing the adhesive side of the sticker.

4. Position the Sticker:

   • Carefully place the exposed adhesive side of the sticker onto the desired location on the surface.
   • Align it according to your preference, making sure it's straight and in the desired position.

5. Apply the Sticker:

   • Once the sticker is positioned, use the credit card or squeegee to smooth out the sticker from the center to the edges.
   • Apply even pressure to ensure good adhesion and to remove any air bubbles.

6. Peel Off the Transfer Tape:

   • If your sticker comes with a transfer tape, peel it off slowly and at a sharp angle, making sure the sticker adheres to the surface.

7. Smooth Out Any Bubbles:

   • If you notice any air bubbles, use the credit card or squeegee to gently push them toward the edges of the sticker, allowing them to escape.

8. Final Check:

   • Carefully inspect the sticker to ensure it's securely adhered to the surface with no bubbles or wrinkles.

9. Let It Set:

   • Allow the sticker to set and adhere to the surface for at least 24 hours before exposing it to extreme conditions, such as water or direct sunlight.

Following these steps should result in a well-applied die-cut sticker. Remember to take your time and be patient during the process to achieve the best results.