Ghostbusters Trap Resistor, GB 2 Aluminium Knob, Shaft, Side Plate & Screws, Hose Connector, Raytheon Knob, shaft & inner plate & Replacement toggle switch

Ghostbusters 2 style aluminium knob comes with shaft enabling the knob to actually turn. Big improvement on the moulded plastic ones of the Spirit Halloween / Rubies traps. Just hacksaw the moulded one off & screw on the plate over it as I have in photos. All holes in plate pre drilled for you. You just need to drill a 7mm hole through the trap wall to push the knob shaft through. For the resistor I just milled & sanded the moulded one down & this new one fits perfectly over where the original one was. Resistors are old stock so serial numbers on them may vary. Supplied with 6 screws to attach the resistor & plate but would still recommend some glue on the back of them as it is only thin plastic & the screws are more for show. 3d printed side skirted Raytheon knob. Again, I just hacksawed the moulded plastic one off. Plate included to glue inside with pre drilled hole to put shaft through for the raytheon knob. You just need to drill a 7mm hole in the rear of the knob & then hot glue it onto the shaft. For the more realistic metal toggle switch you just need to clip the wires off the plastic one on the Spirit / Rubies trap & drill a 12mm hole to accommodate the new toggle switch. For the hose connector it's just a case of drilling a 12mm hole again & screwing in which is a nice tight fit. Kit with Ghostbusters 1 style knob also available on other listing. Also great for custom builds. Any questions then please ask 🙂  Condition is New. Dispatched with Royal Mail 2nd Class.