This device requires a 12vdc 2.5amp power supply (not included) Your supply will connect to the screw terminals of the included green removable Phoenix connector as seen in the photos.
The Vi2308A needs to be deployed along with single port Vi23xxA on the remote end of each UTP cable (not included)
- Extends Ethernet up to 3000 feet! (far beyond the standard 328 feet (100 m) limitation) over UTP
- Extended Pass-Through PoE (PTP™) compatible with 802.3af, at, bt up to 74W
- MegaPixel Certified (MPC™) High data rate, ideal for high bandwidth requirements of MegaPixel cameras, multiple IP cameras systems, and cameras requiring Jumbo Frames
- Symmetric Bandwidth (SBW™) provides consistent upload and download with Virtual Zero Packet Loss (VZPL™)
- Type tested to RFC-2544 TCP/IP network bandwidth packet transmission standards
- Supports one-pair or four-pair UTP wires
- Type tested for -40°C to +75°C temperature range under conforming to NEMA-TS2
- Complies to major IEEE standards and RFC protocols for UDP, TCP/IP, HTTP/HTTPS
The Smart Choice for Transmission Solutions. The MaxiiCopperTM Vi2308A is a revolutionary data transmission device that
extends full-duplex High-Speed Ethernet over existing or new UTP
infrastructures. It extends 10BaseT signals up to 3,000 ft. (909M) and
100BaseT up to 2,100 ft. (640m). It employs MaxiiCopper, an innovative and
unique Ethernet extension technology, that is designed to take full advantage of high-bandwidth UTP cables and maintain a full-duplex 10 or 100
Mb/s Ethernet connection up to the maximum range - with minimum
transmission error and latency. Its dual-rate capability provides an easy way
to balance the best possible network throughput and long-reach distance
design.
The Vi2308A 8 ports:
1 pair of UTP can be used for both 10BaseT
and 100BaseT signals.
4 Pair is restricted to 100BaseT use.
The Vi2308A needs to be deployed along with single port Vi23xxA on the
remote end of each UTP cable.
It is equipped with LEDs to provide link
status and configured data rate for each port. It is completely transparent to
the corporate IP network and higher-layer protocols and requires no IP
programming or other configurations.
The Vi2308A is offered in a 19-inch 1U height enclosure for rack-mount or
wall-mount applications.
It is ideal for medium to large-scale IT networking or digital CCTV projects.
Important Safety Warning
Ethernet Switch/NVR-end Installation
- Connect the chassis ground screw to a solid earth ground.
- Connect the RJ45 connector of the Ethernet switch to the 10/100BaseT
Ethernet port of Vi2308A using a standard Cat5/6 cable of a maximum 100 m
in length.
- Connect long UTP cables to the RJ45 connectors of the Vi2308A.
-
Connect the 12V power supply to the power connector of the extender hub.
The link LED on the 10/100 Ethernet connectors should be “ON” to indicate
proper connection between the switch and Ethernet ports of Vi2308A.
While
the Link LED, Orange for 100BaseT and Green for 10BaseT, on the
extended side, in a steady state will indicate confirmed connection between
extenders.
If no power supply is plugged in the unit will use PoE.
Specifications:
| Electrical | |
| Ethernet Interface | Standard 10/100BaseT |
| Data Rate | Auto select 10/100 Mb/s
Full speed / full duplex at maximum rated distances |
| UTP | 100 Ohm +/- 20%, Cat5 or better
10BaseT: up to 3,000 ft. (914 m)
100BaseT: up to 2,100 ft. (640 m) |
| Power Consumption | 12 VDC@ 600 mA (max.) |
| Status LEDs | Power On
Standard Ethernet: Traffic, Link
Extended Ethernet: Traffic, 10/100BaseT |
| Connectors | Ethernet Interface: 8 x RJ-45 Connectors
Extended Interface: 8 x RJ-45 Connectors
Power: 2-pin Pluggable Terninal Block |
| RFC | 2544 TCP/IP Packet Transmission |
| PoE Compatibility | IEEE 802.3af, at, bt PoE Standards up to 74W |
| RFC | 2544 TCP/IP Packet Transmission
768 UDP, 2068 HTTP, 793 TCP
791 IP, 1783 TFTP, 894 IP over Ethernet
|
| Jumbo Frame Support | Up to 9,600 bytes |
| Regulatory | |
| FCC | Part 15, Subpart B, Class B 2010 |
| Emissions | EN 5502:2006+A1:2007, EN 61000-3-2:2006+A1:2009+A2:2009
EN 61000-3-3:2008, EN 55024:1998+A1:2001+A2:2003 |
| Safety | CE |
| Environmental | RoHS |
| Environmental | |
| Humidity | 0 to 95%, non-condensing |
| Temperature | Operating: -40°C to +75°C
Storage: -40°C to +85°C |
| Mechanical | |
| Dimensions | 0.97x1.75x2 in., 2.5x4.4x5 cm (HxWxL) |
| Weight | 0.15 lb, 67 g |