This is a 3d printed enclosure to house 3.5" + 5.25" floppy drives with the version 4.1 Greaseweazle. The case comes with a power supply installed and comes with a floppy cable and dual molex connector for connecting the drives to the power supply and Greaseweazle as well as 17 screws for mounting the drives to the case and screwing the top and bottom of the case together. This is only for the case + power supply + floppy cable + molex connector + screws and does not include any floppy drives or Greaseweazle. If you would like a case for a different version of Greaseweazle message me and I will see if this is possible.

Note: because the floppy cable doesn't have a "twist" the drives should have different ID's. For example, 3.5" = ID 1 & 5.25" = ID 0 or ID 2 etc

Note 2: some 5.25" floppy drives have the connector on the left side  instead of right when looking from behind. These are rarer but if you have one of these you'll need a longer floppy cable. Ask for the longer floppy cable when ordering if you need one of these.