• Horizontal mounting of the power converter, is recommended although it can be mounted in any position that provides unobstructed ventilation to the fan and vent holes.

• The manufacturer suggests testing the power converter under full load conditions in its intended mounting location. This will ensure that there is sufficient unobstructed ventilation to the converter allowing it to operate at its maximum rated load. Failure to provide adequate ventilation to the converter will cause the converter output to be reduced as it responds to ambient conditions.

• The INTELI-POWER converters are not designed for zero clearance compartments.

• Use a 5/32” hex driver to tighten the output screws. Do not exceed 50 in-lbs. torque on the output terminals.

• The INTELI-POWER converters are not weather tight or designed for wet mounting locations. They must be protected from direct contact with water.

• Avoid the introduction of foreign materials into the case as this could damage or cause a malfunction of the converter.