OmniSlotBox invites you to discover another level of slot racing excitment: JK Cheetah Anglewinder steel 1/32 Slot Car - Peugeot LeMans custom paint Equally at home on large comercial wood tracks and Analog Carrera/OmniSlotBox tracks, these cars steel chassis cars have powerful Falcon 7 motors with smooth 64 Pitch anglewinder gearing. Here is a link to our video about these cars. On our 60' Gran Prix track, good lap times for Carrera cars are 4.5 seconds. These cars are more than a second a lap faster! These cars can stand up to long, hard racing. Despite the very low motor position, there is very little magnetic is downforce from the motor. Instead, superior handling is the result of light weight, low Center of Gravity, balance and wide, sticky rear tires. These cars weigh 90 grams, a typical Carrera cars weights about 130 grams. Every part of these cars is available separately by special order in the unlikely event you need a replacement Rear wheels are superlight, with hybrid aluminum/carbon set screw wheels with very grippy foam tires. A unique asymmetric design maximizes tire width. Replacement rear wheel/tires are available. If the tires wear down too much, yellow tape on the chassis will show marks and prevent sparking of the steel against the rails. Front tires are ultra lightweight because the multi part chassis works best with no front tire contact. On these cars, front wheels are typically represented by stickers on the body. Many bodies are available to fit these chassis both painted and clear. Body prices vary depending on the level of detail and licensing. Because of the high speed and light weight of these cars More aerodynamic bodies improve performance, especially on large tracks. So some bodies compromise scale appearance for aerodynamic downforce. Use of Track Honey track surface treatment strongly recommended to maximize these powerful lightweight cars performance. Foam tires foul quickly on dry dusty tracks. On our tracks, these cars run similar times to the Direct Drive cars, although driving technique is quite different. The anglewinder cars have more punch and brakes, This car is race ready and legal for CARS club racing series. Included are both narrow braid for use on Carrera track and large copper braid for use on tracks with recessed braid. Even it you are not racing with our club, you will find these to be fantastic running cars that will bring a new level of performance to your track. . JK 1/32 steel chassis cars will run an any Carrera Analog (Evolution and Exclusiv) tracks Or with OmniSlotBox but they do "want" more current than standard Carrera power supplies put out, so it is best to have a 3 Amps or more per lane.