Engineer Made

A fun and simple way of exploring the workings of 2 Stroke Engine

I completely stripped the engine then sectioned it,

Cleaned and bead blasted the castings and then applied several coats of primer and paint

I then reassembled it in such a way that it can be revolved by the Flywheel mounted cranking handle,

As the handle is turned the crankshaft goes round which drives the con rod and piston up and down the cylinder, 

The inlet, exhaust and transfer ports can all be seen on this one

the piston has been carefully cleaned to remove the carbon.

It makes a fascinating and very different instructional / educational / unusual desk toy that catches peoples eye. (everyone who sees it cant resist turning the handle)

it will be delivered via a tracked and insured courier.

I do try and keep a few cutaway engines listed however my stock is constantly changing and each engine I section turns out differently so if you see an engine you like, you know what to do.

Approximate dimensions are as follow
Depth 15 cm including Handle
Width 12 cm

Height 20.5 cm Including spark plug

Piston / Bore 36 mm

Weight 1.25 kg (un-packaged)

Please feel free to ask any Questions.
Thanks for looking,