This looks to be an unused item but cannot confirm. Marked used.
Ships via USPS Ground Advantage
International sales welcomed and ship through the eBay Global Shipping Center.
Shipping times will vary if going out of the country. Specified delivery times listed on the ad is to US addresses and will also vary. The eBay Global shipping center is included in that and not the final destination outside of the US.
The information listed below was found online and does not reflect what is included in the sale. It is for reference use:
VEC-514 AutoTuner Extender GENERAL INFORMATION
Does your automatic antenna tuner have limited matching range? Can't auto- tune your antenna on all bands? Do you have to pre-tune your antenna with a manual tuner?
The VEC-514 AutoTuner Extender greatly extends your automatic tuner's matching range. Now you can match nearly any antenna automatically!
The VEC-514 s a heavy duty, wide range impedence transforming device. It has been carefully designed for the flattest frequency response and the lowest loss.
Vectronic's AutoTuner Extender transforms your antenna impedence -- up or down -- by as much as 10 times! The VEC-514 puts nearly any antenna into the matching range of your automatic tuner!
Extend your power range by transforming your antenna impedence so your tuner can be used in a higher power Low-Q mode. The VEC-514 also extends manual antenna tuners.
You can use any tranceiver from 160 through 10 meters with up to 300 watts.
INSTALLATION
The VEC-514 connects in-line between your transmitter and antenna. Connect your transmitters antenna output to the SO-239 connector labeled Transmitter, and your antenna to the Antenna connector. For maximum protection of your tranceiver, a 50 Ohm dummy load should be connected to the plug labeled Dummy Load, and the Ground stud connected to a good RF ground.
OPERATION
The VEC-514 AutoTuner Extender is easy to use! First, bypass your transmitters auto-tuner. Then, while transmitting at a low output power, adjust the knob (from position A through G) on the VEC-514 until you see minimum SWR on your transmitter. Now you're ready to autotune. The Off / Dummy Load position on the knob protects your tranceiver by connecting it to an external dummy load, and by grounding your antenna to bleed off static. The switch position D provides a through connection from your transmitter to your antenna.